Syntax error when attempting to view section parameters
Posted: Thu Aug 10, 2017 1:14 pm
Good afternoon,
I am relatively new to the world of NEURON - I apologize in advance if this has already been answered somewhere else. While attempting to view parameters from the Shape Name window, I am instead given a syntax error reading the following.
//
near line 2
{soma.L}
^
nrnsecmenu(-1,1)
MenuExplore[0].execute("nrnsecmenu...")
MenuExplore[0].make_menu()
//
Any attempts to view other sections' parameters afterwards are greeted with a different error message stating that the previous parameters window has not been closed, although due to the first error there was no window loaded to close out of.
On a side note, I'm certain that there is an easier way to write the code out than the way I did above.
Any help with this would be very much appreciated!
I am relatively new to the world of NEURON - I apologize in advance if this has already been answered somewhere else. While attempting to view parameters from the Shape Name window, I am instead given a syntax error reading the following.
//
near line 2
{soma.L}
^
nrnsecmenu(-1,1)
MenuExplore[0].execute("nrnsecmenu...")
MenuExplore[0].make_menu()
//
Any attempts to view other sections' parameters afterwards are greeted with a different error message stating that the previous parameters window has not been closed, although due to the first error there was no window loaded to close out of.
On a side note, I'm certain that there is an easier way to write the code out than the way I did above.
Any help with this would be very much appreciated!